Ableton Live has no Maximus. Maximus is FL Studio's multiband maximizer: it splits the sound into low, mid and high bands, compresses and limits each one, then limits the whole signal. Live gets close with a few stock devices, and DAWPORT does not convert Maximus, so this page says what to use instead.
2 free conversions every month. No card required.
What DAWPORT does with Maximus
When you convert an FL Studio project to Ableton Live:
- Maximus is not converted. The conversion notes say: "Maximus could not be converted and may be missing from the project. Its original settings are kept in the conversion's recovery data."
- The download includes that recovery data, so the settings are not thrown away.
- A Maximus that was bypassed, or whose Mixer slot mix was at zero, becomes a neutral Utility in Live, because it did not change the sound.
- Everything else on the track still converts. The track simply plays without the Maximus processing.
We checked this on a real FL Studio project with Maximus on several Mixer tracks, converted with DAWPORT 1.1.8.
Closest native devices in Live
| What Maximus does | Closest Live device | Live edition |
|---|---|---|
| Multiband compression, low, mid and high | Multiband Dynamics | Standard or Suite |
| Final ceiling, the master limiter | Limiter | Every edition |
| Gentle glue on the whole mix | Glue Compressor | Standard or Suite |
| Single-band compression | Compressor | Every edition |
| Level and stereo width after the limiter | Utility | Every edition |
These are suggestions for rebuilding by hand, not DAWPORT mappings. Editions are from Ableton's edition comparison, checked on 8 November 2026.
How to rebuild a Maximus chain
- Put Multiband Dynamics where Maximus was, with crossovers near the Maximus band splits.
- Set each band's threshold and ratio by ear, starting gently. Maximus presets are often strong, so compare often.
- Add a Limiter after it and set the ceiling to the level your Maximus ceiling used.
- Match the loudness of your original render, then compare by ear. Louder always sounds "better", so level-match before you judge.
Or keep the exact sound
If the Maximus sound matters, for example on the master, render that track or the whole mix to audio in FL Studio before converting. For a mastered reference, a stereo bounce from FL Studio is the easiest way to compare.
If you used Soundgoodizer
Soundgoodizer is built from Maximus presets, but DAWPORT does convert it: since 1.0.72 it becomes an Audio Effect Rack with Multiband Dynamics and Limiter, labelled as an approximation. See Soundgoodizer in Ableton.
Converting a project
DAWPORT is not affiliated with Image-Line or Ableton. FL Studio, Ableton Live and the device names on this page are trademarks of their respective owners.

