Short answer

The Ableton Live equivalent of Fruity Balance is Utility. Fruity Balance has a volume knob and a pan knob. Utility has Gain and Balance, plus stereo width and mono tools that Fruity Balance doesn't have.

Convert now

2 free conversions every month. No card required.

When DAWPORT converts an FL Studio project to Ableton, Fruity Balance becomes Utility, keeping Live's own device name. You won't see a "Fruity Balance" in your Live Set, because that device doesn't exist in Live.

How the controls correspond

Fruity Balance Ableton Utility Notes
Volume Gain Converted to dB through FL's measured volume curve
Pan Balance See "panned Balance" below
Mixer slot mix knob Folded into Gain With pan centred: FL blends the dry and processed signal; DAWPORT works out the resulting gain
Volume automation Gain automation When pan is centred
Pan automation — Not converted
— Width, Mono, Bass Mono, phase invert Utility extras with no Balance counterpart

FL's volume knob is not a linear dB scale. DAWPORT reads the knob value, converts it to a real gain through a curve measured from FL, then sets Utility's Gain in dB. So a Balance turned down to "half" ends up at a matching level, not at a made-up number.

What DAWPORT does with Fruity Balance

Pan centred. One Utility with the converted gain, the setup you'll see most often. If the Balance's volume is automated, the automation becomes Utility Gain automation in Live.

Pan off centre. FL's pan law and Live's Balance knob don't treat the two sides the same way. So DAWPORT doesn't just copy the pan value. It writes an Audio Effect Rack with two chains, one per input side. A Utility in each chain picks that side, and the chain's volume and pan set the measured left and right levels of the FL setting. If a level would fall outside what the rack can do, that Balance is not converted. A panned Balance with automation is also left out and reported.

Mixer slot mix knob turned down from full. FL mixes the unprocessed and processed signal. For a centred Balance, which is a pure gain device, that is the same as a different gain, so DAWPORT folds it into the Utility gain.

Peak Controller ducking (since 1.0.72). In many FL projects, a Fruity Peak Controller on the kick is linked to a Fruity Balance volume on the bass to make it duck. DAWPORT turns that into sidechained Compressors in Live, placed right after the Utility that replaces the Balance. The notes label this as an approximation. See Fruity Peak Controller in Ableton.

What sounds the same, and what differs

Close in practice:

Different:

Tips for working with it in Live

  1. To tidy up a panned Balance rack, check the level of each chain. Then replace the rack with one Utility, setting Balance by ear until it sounds the same.
  2. For automation you add later, Utility Gain is a good target, just like Fruity Balance volume was in FL.

Related

Questions

What is the Ableton equivalent of Fruity Balance?

Utility. Its Gain knob does the job of Fruity Balance's volume, and its Balance knob does the job of the pan.

Will my converted project show a device called Fruity Balance in Ableton?

No. Fruity Balance doesn't exist in Live, so DAWPORT writes Live's own Utility device under its normal name.

Does Fruity Balance volume automation carry over to Ableton?

Yes, as Utility Gain automation, when the Balance's pan is centred. Pan automation on Fruity Balance is not converted, and a panned Balance with any automation is left out and reported.

What about a Peak Controller linked to a Fruity Balance?

Since DAWPORT 1.0.72, Peak Controller ducking of a Fruity Balance volume can become one or two sidechained Compressors in Live, labelled as an approximation. Settings outside the measured range are not converted.

Convert now